front_panel [IG Manual]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Front Panel ======

^ Indicators: ^^
| AIR	 | Wireless (802.11b/g) |
| PH1 and PH2	| First and second telephone port (FXS) indicator |
| ::: | OFF – Phone not registered |
| ::: | Steady GREEN – Phone registered |
| ::: | Flashing RED – Dialing |
| ::: | Steady RED – In use |
| ::: | GREEN / RED flashing – Message waiting |
| ::: | RED strobe (1.3s off and 0.3s on) – Unavailable |
| LINE	| Telephony gateway indicator |
| ::: | OFF – Not in use |
| ::: | Slow RED flash – Dialing / ringing |
| ::: | Fast RED flash – Extension selection |
| ::: | Steady RED – In use |
| ::: | RED strobe (1.3s off and 0.3s on) – Unavailable |
| USB	| USB memory stick connected |
| ET1-ET4	| Ethernet interface connected |
| WAN	| Status of the Internet connection |

Light - The interface is connected.

No light - The interface is not in use.

Blinking - Indicates that data is being sent or received.

^ Keys: ^^
| SET	| Press and hold for two seconds to enter the set-up mode |
| SEL	| Press to select between different displays/values. Press for two seconds to cancel any set-up. |
| ALT	| Press to select firewall security profile. Press and hold for two seconds to allow remote configuration. |

^ Display: ^^
| AD	| Displays IP address  |
| CFG	| Configure IP address |
| DHP	| - |
| RST	| Reset all configurations to factory defaults |
| LQ	| Line quality (SNR margin) |
| TS	| Transmit speed (Kbps) |
| RS	| Receive speed (Mbps) |