====== Back Panel ====== {{:ix78_back.jpg}}\\ Note: Actual back panel of your Internet Gate model might differ from image above. Certain ports might be missing on cheaper models. ===== LINE ===== [[:ADSL:start|ADSL]] connector, used as WAN port for connecting Internet Gate to the Internet using an ADSL/ADSL2/ADSL2+ connection. Uses middle two pins in connector. [[:phone ports:start|FXO]] connector, used to connect Internet Gate to global telephone network to make and receive ordinary telephone calls. Uses outer two pins in connector. Not used by your Internet Gate. ===== PH2, PH1 ===== [[:phone ports:start|FXS]] connectors allowing connection of up to 5 analogue telephones per port, converting them into IP-phones. PH1 and PH2 can have different SIP addresses (telephone numbers). Not used by your Internet Gate. ===== ET0/WAN ===== If ADSL is used as WAN connection ET0 is on the same subnet as ports ET1, ET2 and ET3. It can however be converted to be the WAN port on the [[:web GUI:Network page]] (disabling ADSL). ET0 is the WAN port for connecting Internet Gate to the Internet using Ethernet. Not present on your Internet Gate. ===== ET1, ET2, ET3 ===== Ethernet switch for connecting clients on your LAN to Internet Gate. All three ports are on the same subnet. ===== ET4 ===== Ethernet port on a different subnet than ET1/2/3, allowing use of a second LAN, or a [[:network:DMZ]]. ===== USB ===== USB 2.0 master port accepting connection of [[:misc:USB|USB memory]]. Not used by your Internet Gate. ===== Antenna ===== [[:wireless|Wireless access point]] with up to three virtual access points (different SSID-s and encryption), on a different subnet as LAN, or bridged to same subnet (controlled on [[:web GUI:Network page]]). Not present on your Internet Gate. ===== DC, ON ===== Power supply connector and power button.