Quick links:
Product Overview
Installation
Settings and Administration
ADSL
SIP Support
Telephone ports
Network
Firewall
Wireless
VPN
Misc
Licenses
Troubleshooting
Differences
This shows you the differences between two versions of the page.
|
troubleshooting:lifeboat [2011/05/24 09:38] tibor |
troubleshooting:lifeboat [2012/06/12 10:36] (current) tibor |
||
|---|---|---|---|
| Line 18: | Line 18: | ||
| - Connect any of Ethernet ports ET1, ET2 or ET3 of your Internet Gate to your PC\\ If your PC has more than one network interface disable all other interfaces but the one used. | - Connect any of Ethernet ports ET1, ET2 or ET3 of your Internet Gate to your PC\\ If your PC has more than one network interface disable all other interfaces but the one used. | ||
| - Unzip the lifeboat file into a folder | - Unzip the lifeboat file into a folder | ||
| - | - Doubleclick on the tftpd32.exe((The lifeboat uses TFTPD32 to transfer the firmware to your unit.\\ TFTPD32 is copyrighted 1998-2006 by Philippe Jounin (philippe@jounin.net).\\ \\ )) icon in that folder.\\ On Windows 7 right-click instead on the icon, select "Run as administrator", and answer "Yes" to the user account control pop-up. | + | - Right-click on the tftpd32.exe((The lifeboat uses TFTPD32 to transfer the firmware to your unit.\\ TFTPD32 is copyrighted 1998-2006 by Philippe Jounin (philippe@jounin.net).\\ \\ )) icon in that folder, select "Run as administrator", and answer "Yes" to the user account control pop-up. |
| - While holding SEL and ALT buttons pressed turn Internet Gate power on. | - While holding SEL and ALT buttons pressed turn Internet Gate power on. | ||
| - Keep SEL and ALT buttons pressed until RST and RS are lit in Internet Gate display, then release the buttons.\\ After a few seconds your Internet Gate displays RST, then CFG RST.\\ Then your Internet Gate displays "Lb" and a rotating bar. Now the firmware in the lifeboat is burned into your Internet Gate's flash memory. This process takes about 2 minutes to finish.\\ After flash burn is finished your Internet Gate reboots. It displays RST, then CFG RST then HELLO. Now it is in normal state and ready to be used. | - Keep SEL and ALT buttons pressed until RST and RS are lit in Internet Gate display, then release the buttons.\\ After a few seconds your Internet Gate displays RST, then CFG RST.\\ Then your Internet Gate displays "Lb" and a rotating bar. Now the firmware in the lifeboat is burned into your Internet Gate's flash memory. This process takes about 2 minutes to finish.\\ After flash burn is finished your Internet Gate reboots. It displays RST, then CFG RST then HELLO. Now it is in normal state and ready to be used. | ||
