Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| settings_and_administration:front_panel_configuration [2011/03/15 15:55] – tibor | settings_and_administration:front_panel_configuration [2012/07/09 10:09] (current) – tibor | ||
|---|---|---|---|
| Line 26: | Line 26: | ||
| * After all four sections of the subnet mask has been specified the IP address and mask is saved in memory. | * After all four sections of the subnet mask has been specified the IP address and mask is saved in memory. | ||
| + | <if !media5> | ||
| ===== DHP - Read from USB ===== | ===== DHP - Read from USB ===== | ||
| Read configuration or flash image from attached USB memory.(Only shown if there is an /ix78 directory in attached USB memory.) | Read configuration or flash image from attached USB memory.(Only shown if there is an /ix78 directory in attached USB memory.) | ||
| Line 32: | Line 33: | ||
| * Press SEL to access USB memory stick again: | * Press SEL to access USB memory stick again: | ||
| * “FLI” is shown if there is an / | * “FLI” is shown if there is an / | ||
| + | </if> | ||
| ===== RST - Reset all settings to factory defaults ===== | ===== RST - Reset all settings to factory defaults ===== | ||
| * Asks “clear all?” and then displays “no”. | * Asks “clear all?” and then displays “no”. | ||
| - | * Press SEL button to change to “YES” and press SET to wipe out all your settings | + | * Press SEL button to change to “YES” and press SET to wipe out all your settings, restore them to factory defaults, and reboot the unit. |
| - | * If holding ALT button pressed 3 seconds instead of pressing SEL above then “YES.” (observe the dot) is displayed instead. Pressing SET now will only reset the unit’s password to admin/ | + | * If holding ALT button pressed 3 seconds instead of pressing SEL above then “YES.” (observe the dot) is displayed instead. Pressing SET now will only reset the unit’s password to admin/ |
| ===== LQ - Perform diagnostic tests ===== | ===== LQ - Perform diagnostic tests ===== | ||
