Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| web_gui:extra_wan_interfaces [2010/11/09 13:41] – mats | web_gui:extra_wan_interfaces [2010/11/19 10:46] (current) – tibor | ||
|---|---|---|---|
| Line 7: | Line 7: | ||
| A common configuration of this is the " | A common configuration of this is the " | ||
| - | Read more: [[network: | + | Read more: [[network: |
| + | {{ : | ||
| ===== Common interface parameters ===== | ===== Common interface parameters ===== | ||
| Line 20: | Line 21: | ||
| **Gateway** The address of the next router up in the network. For the Internet interface, this is the unit's [[wp> | **Gateway** The address of the next router up in the network. For the Internet interface, this is the unit's [[wp> | ||
| For the other interfaces, this is the "next hop" i.e. the address of the router that takes care of the packet sent upstreams on this particular channel (subnet). | For the other interfaces, this is the "next hop" i.e. the address of the router that takes care of the packet sent upstreams on this particular channel (subnet). | ||
| - | Leave empty when using DHCP or PPPoE/ | + | :!: Leave empty when using DHCP or PPPoE/ |
| **Access type** The protocol and/or method of acquiring the IP address. | **Access type** The protocol and/or method of acquiring the IP address. | ||
| Line 27: | Line 28: | ||
| **User (PPP), Password (PPP)** Username and password if a Point-to-Point protocol (PPPoE, PPPoA) is used. [[wp> | **User (PPP), Password (PPP)** Username and password if a Point-to-Point protocol (PPPoE, PPPoA) is used. [[wp> | ||
| - | **IGMP Proxy** Check this if the interface is the upstream interface for the IGMP Proxy. | + | **IGMP Proxy** Check this if the interface is the upstream interface for the [[network: |
| This is typically used for multicast traffic, such as video. NB! Only one such interface may be selected. | This is typically used for multicast traffic, such as video. NB! Only one such interface may be selected. | ||
| - | If none are selected, the normal WAN interface is the upstream IGMP interface. | + | :!: If none are selected, the normal WAN interface is the upstream IGMP interface. |
| If multicast is to be used, it must be enabled on the security settings too. | If multicast is to be used, it must be enabled on the security settings too. | ||
| Line 36: | Line 37: | ||
| Notably, the SIP traffic is specially marked by values 4, 7, 261 or 262. | Notably, the SIP traffic is specially marked by values 4, 7, 261 or 262. | ||
| The value 4 corresponds to the "Use WAN Interface with special SIP QoS" checkbox on the SIP page. | The value 4 corresponds to the "Use WAN Interface with special SIP QoS" checkbox on the SIP page. | ||
| - | The numbers used here are internal class identifications and does not necessarily imply any priority value. | + | :!: The numbers used here are internal class identifications and does not necessarily imply any priority value. |
| The " | The " | ||
| Line 77: | Line 78: | ||
| A //VLAN Id// is a value between 0 and 4094 defining the identification of the particular channel (network). | A //VLAN Id// is a value between 0 and 4094 defining the identification of the particular channel (network). | ||
| - | All or none of the //VLAN Id// fields must be filled in. | + | :!: All or none of the //VLAN Id// fields must be filled in. |
| If VLAN tags are used and a single interface should receive non-tagged traffic, its //VLAN Id// field should be set to the (fictitious) value 4096. | If VLAN tags are used and a single interface should receive non-tagged traffic, its //VLAN Id// field should be set to the (fictitious) value 4096. | ||
| It is also possible to have extra WAN interfaces on the Ethernet WAN port using only non-VLAN-tagged traffic. | It is also possible to have extra WAN interfaces on the Ethernet WAN port using only non-VLAN-tagged traffic. | ||
| In this case, the " | In this case, the " | ||
| - | However, broadcast packets will be reveived on all IP interfaces, with implications to for example DHCP services. | + | However, broadcast packets will be reveived on all IP interfaces, with implications to for example DHCP services |
| In practise, it is as if multiple IP interfaces would be connected to WAN through the same Ethernet switch (hub). | In practise, it is as if multiple IP interfaces would be connected to WAN through the same Ethernet switch (hub). | ||
| In this case, the //VLAN Id// fields should be left empty. | In this case, the //VLAN Id// fields should be left empty. | ||
| Line 94: | Line 95: | ||
| The bridge is like connecting through a hardware switch/hub. [[wp> | The bridge is like connecting through a hardware switch/hub. [[wp> | ||
| - | The ordinary WAN " | + | :!: The ordinary WAN " |
| ===== Extra QoS classifiers ===== | ===== Extra QoS classifiers ===== | ||
| - | As packets come in on a LAN port they may be marked with QoS tags, this is done by the " | + | As packets come in on a LAN port they may be marked with QoS tags, this is done by the " |
| + | The QoS tag value, if set, will force the router to send the packet out by a particular WAN interface - if one is configured for that "QoS routing" | ||
| + | By setting up the search profiles in the table here, one may direct packets with certain source/ | ||
| + | Select the WAN interface implicitly by using the "QoS routing" | ||
| Thus, the settings here only apply to upstream traffic. | Thus, the settings here only apply to upstream traffic. | ||
| - | **Order** The order may be important when the " | + | **Order** The order may be important when the " |
| + | A low order number profile (=row) will be tried before a higher order: if a match the higher order will not be evaluated for a that packet. | ||
| + | This implies that a more specific profile should be placed before the more general. | ||
| - | **QoS routing** This directs on which output interface the packets will go, that is, those packets conforming to the IP address(es), | + | **QoS routing** This directs on which output interface the packets will go, that is, those packets conforming to the IP address(es), |
| + | The numbers used in the dropdown box are internal class identifications and does not necessarily imply any priority value. | ||
