This is an old revision of the document!
Internet Access Problems
On the front panel display the text Hi, Lo or AC indicates that there is a working WAN (Internet) connection.
If this is not the case, you have probably one of the following display appearances:
- blank, apart from a single dot in the lower right corner. This indicates that there is no low-level link (i.e. no Ethernet link in case of Ethernet type of WAN, or no ADSL link) on the WAN interface.
- If using Ethernet as the WAN port:
Check the cables. When an Ethernet link is established, the WAN led (on 4-port models the ET4 led) should be lit, “100” is displayed for a short while on the display, and there is a message “Link up” entered in the system log. - If using ADSL as the WAN port:
Check the ADSL cables and connectors, and proceed by the ADSL Connection Troubleshooting scheme.
- a rolling figure-of-eight, accompanied by the text
IP. This shows that the low-level link has been properly established but the modem has not got its IP address on the WAN interface.- Check the settings of the VPI/VCI values on the Network page.
- If using the Access type PPPoE or PPPoA on the Network page, check the settings of the User and Password.
- Check if there is any kind of error message in the system log.
If you have problems accessing the Internet from a PC on the LAN, follow this procedure:
(This assumes that you want to use the Internet Gate as a router and use it to assign IP addresses to all the devices on your local network.)
- Check that there is a working connection between the PC and the Internet Gate, follow the instructions here.
- Check the Internet (WAN) connection as described above. You must have the
Hi,LoorACon the display.
