Differences

This shows you the differences between two versions of the page.

--- network:operational_modes [2011/06/15 10:23]
tibor
+++ network:operational_modes [2011/08/26 16:51] (current)
tibor
@@ Line 16: / Line 16: @@
 ===== SIParator =====
-(requires purchase of [[:license]]) SIP- and RTP-proxy allowing SIP clients behind a non-SIP-aware firewall to connect to the Internet. The unit is placed in parallel with your existing firewall.
+(requires purchase of [[:license]])\\
+SIP- and RTP-proxy allowing SIP clients behind a non-SIP-aware firewall to connect to the Internet. The unit is placed in parallel with your existing firewall.
 {{:network:siparator.jpg|}}
@@ Line 27: / Line 28: @@
 ===== WAN SIParator 1 =====
-(requires purchase of [[:license]]) Like SIParator, but bridging the WAN port to an existing firewall connected to the ET4 port, and sharing a single IP address with that unit.
+(requires purchase of [[:license]])\\
+Like SIParator, but bridging the WAN port to an existing firewall connected to the ET4 port, and sharing a single IP address with that unit.
 {{:network:wansiparator1.jpg|}}
-NOTE: Older units without ET0 port cannot be configured to WAN SIParator 1 mode.
+NOTE: WAN Siparator mode 1 cannot be used with PPPoA and PPPoE connections. \\
+NOTE: Older units without ET0 port must use ADSL as WAN in SIParator 1 mode.
 ===== WAN SIParator 2 =====
@@ Line 41: / Line 44: @@
 The WAN SIParator 1 and WAN SIParator 2 modes, with their resp. bridge settings, are reflected on the Network Advanced page, under the box [[web_gui:advanced_network_configuration#Bridge (802.1D) WAN to ET4|"Bridge (802.1D) WAN to ET4"]].
-NOTE: Older units without ET0 port cannot be configured to WAN SIParator 2 mode.
+NOTE: Older units without ET0 port must use ADSL as WAN in SIParator 2 mode.
 ===== LAN SIParator =====

network/operational_modes.1308126237.txt.gz · Last modified: 2011/06/15 10:23 by tibor

Show page Old revisions