This is an old revision of the document!
Table of Contents
Front Panel
Indicators
There are several lamps indicating interface status:
| Indicators: | |
|---|---|
| AIR | Wireless (802.11b/g) |
| PH1 and PH2 | First and second telephone port (FXS) indicator |
| OFF – Phone not registered | |
| Steady GREEN – Phone registered | |
| Flashing RED – Dialing | |
| Steady RED – In use | |
| GREEN / RED flashing – Message waiting | |
| RED strobe (1.3s off and 0.3s on) – Unavailable | |
| LINE | Telephony gateway indicator |
| OFF – Not in use | |
| Slow RED flash – Dialing / ringing | |
| Fast RED flash – Extension selection | |
| Steady RED – In use | |
| RED strobe (1.3s off and 0.3s on) – Unavailable | |
| USB | USB memory stick connected |
| ET1-ET4 | Ethernet interface connected |
| WAN | Status of the Internet connection |
Light - The interface is connected.
No light - The interface is not in use.
Blinking - Indicates that data is being sent or received.
Keys
Three buttons allow you configure the unit:
| Keys: | |
|---|---|
| SET | Press and hold for two seconds to enter the set-up mode |
| SEL | Press to select between different displays/values. Press for two seconds to cancel any set-up. |
| ALT | Press to select firewall security profile. Press and hold for two seconds to allow remote configuration. |
Keys can be disabled on the Administration page.
Display
The 3-digit display shows status and allows configuration. Above and to the right of the 3 digits are small text indicators showing what is currently displayed:
| Display: | |
|---|---|
| AD | Displays IP address |
| CFG | Configure IP address |
| DHP | - |
| RST | Reset all configurations to factory defaults |
| LQ | Line quality (SNR margin) |
| TS | Transmit speed (Kbps) |
| RS | Receive speed (Mbps) |
Read more about front_panel_configuration.
