Quick links:
Product Overview
Installation
Settings and Administration
ADSL
SIP Support
Telephone ports
Network
Firewall
Wireless
VPN
Misc
Licenses
Troubleshooting
This is an old revision of the document!
There are several lamps indicating interface status:
Indicators: | |
---|---|
AIR | Wireless (802.11b/g) |
PH1 and PH2 | First and second telephone port (FXS) indicator OFF – Phone not registered Steady GREEN – Phone registered Flashing RED – Dialing Steady RED – In use GREEN / RED flashing – Message waiting RED strobe (1.3s off and 0.3s on) – Unavailable |
LINE | Telephony gateway (FXO) indicator: OFF – Not in use Slow RED flash – Dialing / ringing Fast RED flash – Extension selection Steady RED – In use RED strobe (1.3s off and 0.3s on) – Unavailable ADSL status indicator: Slow GREEN flash - ADSL training Steady GREEN - ADSL connected (FXO idle) GREEN flicker - ADSL data sent or received |
USB | USB memory stick connected |
ET1-ET4 | Ethernet interface connected |
WAN | Status of the Internet connection |
Light - The interface is connected.
No light - The interface is not in use.
Blinking - Indicates that data is being sent or received.
Three buttons allow you configure the unit:
Keys: | |
---|---|
SET | Press and hold for two seconds to enter the set-up mode |
SEL | Press to select between different displays/values. Press for two seconds to cancel any set-up. |
ALT | Press to select firewall security profile. Press and hold for two seconds to allow remote configuration. |
Keys can be disabled on the Administration page.
The 3-digit display shows status and allows configuration. Above and to the right of the 3 digits are small text indicators showing what is currently displayed:
Display: | |
---|---|
AD | Displays IP address |
CFG | Configure IP address |
DHP | - |
RST | Reset all configurations to factory defaults |
LQ | Line quality (SNR margin) |
TS | Transmit speed (Kbps) |
RS | Receive speed (Mbps) |
Read more about front panel configuration.