Front Panel

Indicators

There are several lamps indicating interface status:

Indicators:
AIR	Wireless (802.11b/g)
PH1 and PH2	First and second telephone port (FXS) indicator OFF – Phone not registered Steady GREEN – Phone registered Flashing RED – Dialing Steady RED – In use GREEN / RED flashing – Message waiting RED strobe (1.3s off and 0.3s on) – Unavailable
LINE	Telephony gateway (FXO) indicator: OFF – Not in use Slow RED flash – Dialing / ringing Fast RED flash – Extension selection Steady RED – In use RED strobe (1.3s off and 0.3s on) – Unavailable ADSL status indicator: Slow GREEN flash - ADSL training Steady GREEN - ADSL connected (FXO idle) GREEN flicker - ADSL data sent or received
USB	USB memory stick connected
ET1-ET4	Ethernet interface connected
WAN	Status of the Internet connection

Light - The interface is connected.

No light - The interface is not in use.

Blinking - Indicates that data is being sent or received.

Keys

Three buttons allow you configure the unit:

Keys:
SET	Press and hold for two seconds to enter the set-up mode
SEL	Press to select between different displays/values. Press for two seconds to cancel any set-up.
ALT	Press to select firewall security profile. Press and hold for two seconds to allow remote configuration.

:!: Keys can be disabled on the Administration page.

Display

The 3-digit display shows status and allows configuration. Above and to the right of the 3 digits are small text indicators showing what is currently displayed:

Display:
AD	Displays IP address
CFG	Configure IP address
DHP	-
RST	Reset all configurations to factory defaults
LQ	Line quality (SNR margin)
TS	Transmit speed (Kbps)
RS	Receive speed (Mbps)