Quick links:
Product Overview
Installation
Settings and Administration
ADSL
SIP Support
Telephone ports
Network
Firewall
Wireless
VPN
Misc
Licenses
Troubleshooting
Table of Contents
Front Panel
Indicators
There are several lamps indicating interface status:
| Indicators: | |
|---|---|
| AIR | Wireless (802.11b/g) |
| PH1 and PH2 | First and second telephone port (FXS) indicator OFF – Phone not registered Steady GREEN – Phone registered Flashing RED – Dialing Steady RED – In use GREEN / RED flashing – Message waiting RED strobe (1.3s off and 0.3s on) – Unavailable |
| LINE | Telephony gateway (FXO) indicator: OFF – Not in use Slow RED flash – Dialing / ringing Fast RED flash – Extension selection Steady RED – In use RED strobe (1.3s off and 0.3s on) – Unavailable ADSL status indicator: Slow GREEN flash - ADSL training Steady GREEN - ADSL connected (FXO idle) GREEN flicker - ADSL data sent or received |
| USB | USB memory stick connected |
| ET0-ET4 | Ethernet interface connected |
Light - The interface is connected.
No light - The interface is not in use.
Blinking - Indicates that data is being sent or received.
Keys
Three buttons allow you configure the unit:
| Keys: | |
|---|---|
| SET | Press and hold for three seconds to enter the set-up mode |
| SEL | Press to select between different displays/values. Press for three seconds to cancel and leave set-up mode. Press for 10 seconds to turn wireless access point on or off. |
| ALT | Press to select firewall security profile. Press and hold for three seconds to allow remote configuration. |
Keys can be disabled on the Administration page.
By keeping some buttons pressed during power on unit can enter special modes.
Display
The 3-digit display shows status and allows configuration. Above and to the right of the 3 digits are small text indicators showing what is currently displayed:
| Normal mode: | |
|---|---|
| AD | - |
| CFG | Configuration has been changed without saving it permanently. Powering off unit will result in loosing your changes. |
| DHP | - |
| RST | Unit is in safe mode, using default values temporarily. |
| LQ | Line quality (SNR margin) |
| TS | Transmit speed (Kbps) |
| RS | Receive speed (Mbps) |
| Configuration mode: | |
| AD | View IP address / View MAC address |
| CFG | Edit IP address / Save settings permanently |
| DHP | Read from USB |
| RST | Reset to factory defaults |
| LQ | Perform diagnostic test |
| TS | - |
| RS | Collect debug information |
