Initial Installation

This topic describes the installation procedure for the most common installation scenario where the Internet Gate is used as a router on a local network to share a single connection to the Internet.

For other installation scenarios please refer to the installation information provided with your unit.

Connect the splitter supplied with your Internet Gate to the main telephone connector in your home. Connect Internet Gate's LINE port with the splitter.

Connect a PC to Internet Gate's ET1 port. The PC shall use DHCP to acquire its IP address and other settings (as it is default in Windows).

Connect the power supply to Internet Gate and turn power on using the button on the back panel. Internet Gate should now display first RST, then CFG RST, then after a couple of seconds HELLO in its display.

Start a web browser on the PC attached to ET1 and enter http://192.168.0.1 into the browser's address field.

On the appearing Login page click “Log in” and enter username admin password admin.

If you cannot browse to the Login page check connect to GUI troubleshooting.

If your Internet Provider doesn't require any special log in you should now be able to access the Internet. Try surf to an external web site (for instance: http://www.intertex.se). If you manage to reach the Internet continue to next header below.

Some Internet Providers require their users to log in before they can access the Internet. If you have received a username and a password from your Internet Provider then you need to enter those on the Network page (select “Access type: Auto” to see the User and Password fields).

Select Access type:Auto and click Search to allow Internet Gate to try to connect to your Internet Provider. If it fails then you need to enter access type information manually, consult your Internet Provider.

If you cannot reach the Internet check Internet access problems troubleshooting.