Differences

This shows you the differences between two versions of the page.

--- web_gui:adsl_advanced [2011/04/29 11:18]
tibor created
+++ web_gui:adsl_advanced [2011/04/29 14:43] (current)
tibor
@@ Line 2: / Line 2: @@
 ^ For advanced users only! ^
 | Wrong settings decrease ADSL performance or make ADSL stop working completely. |
-:!: Leave most settings as they are - changing them only degrades performance.
 {{ :web_gui:adsl_advanced.png?286|ADSL Advanced in rel 5.30}}
@@ Line 11: / Line 9: @@
   * ADSL2 and ADSL2+ AnnexM settings ((The Annex B firmware has corresponding sets, but lacks the AnnexM mode))
 You select the correct advanced settings page using the advanced links in the ADSL modes field of the [[ADSL page]].
+===== Stop/Restart =====
+Most ADSL settings require current ADSL connection to be stopped and a new one started to became effective. With the Stop/Start and Restart buttons you can bring your ADSL connection down and up again.\\
+(For information about operational mode and ADSL line state see [[ADSL page]].)
+===== Advanced =====
+:!: Leave most settings as they are - changing them only degrades performance.
 Some ADSL mode's Advanced Settings page may be missing some of the entries below as they are not applicable to that mode.
@@ Line 18: / Line 23: @@
 === SHalf ===
+S=1/2 is an ADSL mode obsoleted by ADSL2. In S=1/2 mode higher throughput (up to 12Mbps) is achieved over plain ADSL connection using interleaved data path. Only a few service providers support S=1/2 mode.
 === Cabinet Mode ===

web_gui/adsl_advanced.1304068701.txt.gz · Last modified: 2011/04/29 11:18 by tibor